Brushless Rage Presales Open!

Tuesday, August 29th, 2017 @ 0:18 | Motor Controllers

HEY YOU! Go pre-order some BRUSHLESS RAGES! After months of little fine adjustments, some of which has been documented here (and others will be), I’m finally ready to push them to release. There won’t be an Indiegogo this time, just open pre-orders on Equals Zero Designs. The estimated shipdate for pre-orders occurring this month is November! You all have seen what Brushless Rage is capable of and what niche it fills, so hopefully that’s enough!

Updates for the robots this Dragon Con season will come soon! Überclocker/30-haul is coming (finally), and Roll Cake shall rise again…

 

Recently

  • The Overhaul Design and Build Series, Part 5: “Don’t you have to ship this on Wednesday, dude?”
  • The Overhaul Design & Build Series, Part 4: Do You Want to be Gooey?
  • The Overhaul 2018 Design and Build Series, Part 3: When Your Supply Chain is Missing a Half-Link
  • The Overhaul 2018 Design and Build Series, Part 2: Where Everything Gets Easier
  • The Overhaul 2018 Design & Build Series, Part 1: Because of The Implications
  • Motorama 2018: How Not to Scale Model Test Your BattleBots, The Remix
  • Operation RESOLUTE BROWN: Vantruck Justice and Motorama 2018; Installing a Gear Vendors Overdrive
  • My Life is Ruined Again: BattleBots Season 3 and the Triumphant Return (?) of Overhaul
  • Charles’ CES 2018 Insanity Tour, Part III: Deck the Halls with Chinesium
  • Charles’ CES 2018 Insanity Tour Part II: Revenge of the 30-Foot Wearable Blockchain Vape-as-a-Service
  •  

    2 Responses to “Brushless Rage Presales Open!”

    1. Brian Says:

      Didn’t you burn through 3 of these at makerfaire Detroit?

    2. the chuxxor Says:

      Haha, the signal boards popped off since I didn’t secure them (besides the connector) on Chibikart – and it has 4″ solid rubber wheels, going over parking lot cracks.

      Those two were repaired after I got back – they each lost 1 FET and 1 driver chip from the phase which fell off first. The two I put on Chibikart after had VHB tape holding the sigboards on.